I am asking because I am thinking of buying one.ZDNET's recommendations are based on many hours of testing, research, and comparison shopping. You MUST work your way from the center out, otherwise you will have wrinkles.ĭo you have any pics of the fludesigns cover and how do you like the cover / material? Then work your way from the center (where the bend is) to the front and then center to the back eliminating wrinkles as you go. Like he said, staple both ends lightly and make sure everything is aligned. Upholstery is easy if you can live with some wrinkles but it's a bitch if you want it done right (I know. Finally trim excess material with sharp knife around seat mounts, front, back and sides. Finish installation by placing staples 1/2"(1.27cms) apart on the front, back, and knee area and 1"(2.54cms) apart along the sides. If there are still wrinkles in the seat, remove staples from that area to stretch and re-staple.Ĥ. Repeat this process from the knee area to the back. Continue to stretch and staple the front section from the knee area to the top evenly. Next stretch the sides over the knee area located at the bend of the base and staple. Staple front and back with 2-3 staples only and re-check alignment.ģ. First pull the seat cover over the front of the foam and then over the back, aligning the centre of the seat cover with the foam. Make sure the new seat cover is at optimum temp of 70F - 90F. Here are the instructions if you want to give it a go.ġ. After mocking up my factory effects gripper seat cover it looked like there would be too much around to get it right so i took it to an auto trimmer who did it for $15AUS and did a great job.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |